Installing Shower Door Handles For Frameless Doors

Author: | Categories: Door Ideas comments
Shower Door Handles Replacement

Hardware, including shower door handles, closures and hinges for glass frameless shower doors are installed using a carbide drill to bore holes through the glass. Replacement handles for frameless shower doors are typically installed by aligning the inner and outer handles with the installation holes, then passing several screws or an internal handle screw, through the glass, into the base of the outer handle. The positions of the screw holes in the replacement handles should be identical to those in the original handle. Fortunately, replacement handles with a space between standard holes are available in more improvements and plumbing supply stores.

READ  Best as Modern Exterior Doors

Inspect the shower door handles assembly to determine that the handle should be installed on the external surface of the door. The inner handle usually has one or two holes, while the outer handle has a smooth finish. Then, place the external handle on the outside of the shower door, align your screw holes in the drilled holes in the glass door. Use a piece of tape, 8 to 10 inches long, to temporarily hold the outer handle in place.

READ  Frameless Sliding Shower Doors to Bring Elegance

Place the internal handle on the inside of the shower door, aligning your screw holes in the drilled holes in the glass door. Pass the tip of the screw, included in the handle shower kit, through the screw hole in the handle of the indoor shower. Use a screwdriver to tighten the screw. Do not over tighten the screw, as this can cause the glass to break. If the shower door handles has several screws, install these in the same way.

Comments are closed.